The AD9484 OR (overrange) LVDS pair is routed on the 50T main board to
xc7a50t-ftg256 bank-14 pins M6/N6 but was previously left unconnected at
the top level. Plumb it through the full stack so saturation at the raw
ADC boundary shows up in the existing overflow aggregation:
- ad9484_interface_400m: add adc_or_p/n inputs, IBUFDS + IDDR capture of
both phases in the BUFIO domain, re-register into the clk_400m BUFG
domain, OR rise|fall into adc_overrange_400m output.
- radar_receiver_final: stickify adc_overrange_400m in clk_400m, CDC to
clk_100m via a 2FF ASYNC_REG chain (same reasoning as F-1.2's
cdc_cic_fir_overrun — single-bit, latched low→high, GPIO-class
diagnostic), OR into the existing ddc_overflow_any aggregation.
- radar_system_top: expose adc_or_p/n top-level ports and pass through.
- xc7a50t_ftg256.xdc: anchor M6/N6 as LVDS_25 DIFF_TERM, with the same
DCO-relative input-delay constraints as adc_d_p[*].
- xc7a200t_fbg484.xdc: IOSTANDARD/DIFF_TERM set; PACKAGE_PIN left as a
documented TODO — the 200T dev-board schematic has not been checked
and the 200T build will need the anchor filled in before place/route.
Jason
951390f678