e93bc33c6c
Production fixes 1-7: detection bugs, cfar→threshold rename, digital gain control, Doppler mismatch protection, decimator watchdog, bypass_mode dead code removal, range-mode register (21/21 regression PASS)
...
Fix 1: Combinational magnitude + non-sticky detection flag (tb: 23/23)
Fix 2: Rename all cfar_* signals to detect_*/threshold_* (honest naming)
Fix 3: New rx_gain_control.v between DDC and FFT, opcode 0x16 (tb: 33/33)
Fix 4: Clamp host_chirps_per_elev to DOPPLER_FFT_SIZE, error flag (E2E: 54/54)
Fix 5: Decimator watchdog timeout, 256-cycle limit (tb: 63/63)
Fix 6: Remove bypass_mode dead code from ddc_400m.v (DDC tb: 21/21)
Fix 7: Range-mode register 0x20 with status readback (USB tb: 77/77)
2026-03-20 04:38:35 +02:00
0773001708
E2E integration test + RTL fixes: mixer sequencing, USB data-pending flags, receiver toggle wiring (19/19 FPGA)
...
RTL fixes discovered via new end-to-end testbench:
- plfm_chirp_controller: TX/RX mixer enables now mutually exclusive
by FSM state (Fix #4 ), preventing simultaneous TX+RX activation
- usb_data_interface: stream control reset default 3'b001 (range-only),
added doppler/cfar data_pending sticky flags, write FSM triggers on
range_valid only — eliminates startup deadlock (Fix #5 )
- radar_receiver_final: STM32 toggle signals wired through for mode-00
pass-through, dynamic frame detection via host_chirps_per_elev
- radar_system_top: STM32 toggle signal wiring to receiver instance
- chirp_memory_loader_param: explicit readmemh range for short chirp
Test infrastructure:
- New tb_system_e2e.v: 46 checks across 12 groups (reset, TX, safety,
RX, USB R/W, CDC, beam scanning, reset recovery, stream control,
latency budgets, watchdog)
- tb_usb_data_interface: Tests 21/22/56 updated for data_pending
architecture (preload flags, verify consumption instead of state)
- tb_chirp_controller: mixer tests T7.1/T7.2 updated for Fix #4
- run_regression.sh: PASS/FAIL regex fixed to match only [PASS]/[FAIL]
markers, added E2E test entry
- Updated rx_final_doppler_out.csv golden data
2026-03-20 01:45:00 +02:00
7cdfa486e5
Gap 2 GUI Settings: runtime chirp timing, stream control gating, status readback (18/18 FPGA, 20/20 MCU)
...
Register map: 0x10-0x15 chirp timing overrides, 0xFF status readback,
0x03 CFAR threshold now wired to actual compare, 0x04 stream control
gates USB write FSM. Status readback sends 7-word packet (0xBB header,
5 status words, 0x55 footer) via toggle CDC.
radar_mode_controller: 6 cfg_* input ports replace hardcoded parameters.
usb_data_interface: stream_control CDC, status_request toggle CDC,
SEND_STATUS state (3'd7), stream gating in IDLE/HEADER/RANGE/DOPPLER.
radar_system_top: 6 host registers + command decode for 0x10-0x15/0xFF.
radar_receiver_final: 6 host_* timing passthrough ports.
Testbench coverage: RMC 81 checks (+TG16 runtime reconfig), USB 77
checks (+TG15 stream gating, TG16 status readback, TG17 chirp opcodes).
Fixed iverilog 13.0 forward-ref for status_req_toggle_100m.
2026-03-19 23:54:48 +02:00
e5d1b3cfc3
Gap 4 USB Read Path: wire host-to-FPGA command path with toggle CDC, add read path tests
...
- usb_data_interface.v: Add FT601 read FSM (RD_IDLE/OE_ASSERT/READING/
DEASSERT/PROCESS) + cmd_data/valid/opcode/addr/value output ports
- radar_system_top.v: Connect cmd_* ports from usb_inst, add toggle CDC
for cmd_valid (ft601_clk -> clk_100m), add command decode registers
(mode/trigger/cfar_threshold/stream_control), wire host_mode and
host_trigger to rx_inst
- radar_receiver_final.v: Add host_mode[1:0] and host_trigger input
ports, replace hardcoded mode/trigger in radar_mode_controller instance
- tb_usb_data_interface.v: Connect cmd_* ports, add host data bus driver,
add Test Groups 12 (single command), 13 (multiple commands), 14
(read/write interleave). USB TB now has 55 checks.
Regression: 18/18 PASS
2026-03-19 23:16:26 +02:00
3fa26c9e4c
Wire matched filter range profile to USB, replacing Doppler placeholder
2026-03-19 12:33:40 +02:00
f6877aab64
Phase 1 hardware bring-up prep: ILA debug probes, CDC waivers, programming scripts
...
- Rename latency_buffer_2159 -> latency_buffer (module + file + all refs)
- Add CDC waivers for 5 verified false-positive criticals to XDC
- Add ILA debug probe insertion script (4 cores, 126 probe bits, 2 clock domains)
- Add FPGA programming script (7-step flow with DONE pin verification)
- Add ILA capture script (4 scenarios + health check, CSV export)
- Add debug_ila.xdc with MARK_DEBUG fallback attributes
- Full regression clean: 13/13 suites, 266/266 checks, 2048/2048 golden match
2026-03-18 01:28:42 +02:00
fd6094ee9e
Fix P0/P1 RTL bugs found during pre-hardware audit
...
P0-1: nco_400m_enhanced.v — DSP48E1 OPMODE corrected from PCIN to P
feedback (was routing stale cascade data into accumulator)
P0-2: radar_receiver_final.v — removed same-clock CDC that corrupted
ADC data path between ad9484_interface and DDC
P1-5: fir_lowpass.v — fixed zero replication count in coefficient
symmetric extension ({0{1'b0}} is empty, now uses explicit 0)
Also updates .gitignore to exclude debug/scratch artifacts.
All 30+ testbenches pass (unit, co-sim, integration).
2026-03-16 22:24:06 +02:00
e76925391c
Fix multi-seg/chain handshake deadlock + add radar_receiver_final integration test (10/10 PASS)
...
RTL fix: matched_filter_multi_segment.v ST_WAIT_FFT now waits for
processing chain to complete ALL 1024 outputs and return to IDLE
before advancing to next segment. Previously, it transitioned on the
first fft_pc_valid edge, causing the chain to still be outputting
while multi-seg started collecting data for the next segment. This
broke the handshake and caused permanent deadlock after segment 0.
Also fixes forward reference of sample_addr_from_chain in
radar_receiver_final.v (declaration moved before first use).
New files:
- tb/tb_radar_receiver_final.v: P0 integration test for full RX
pipeline (ADC->DDC->MF->range_bin_decimator->doppler), 10 checks
- tb/ad9484_interface_400m_stub.v: behavioral ADC stub for iverilog
All existing tests still pass: multi-seg 32/32, MF co-sim 3/3,
Doppler co-sim 14/14.
2026-03-16 18:51:08 +02:00
eefaf94e9e
Fix 6 RTL files + add xfft_32 stub for successful Vivado synthesis
...
Resolves all synthesis errors across attempts 3-11, achieving clean
Vivado 2025.2 synthesis on XC7A100T (0 errors, 831 LUTs, 320 FFs, 2 DSPs).
radar_receiver_final.v:
- reg clk_400m -> wire; output reg -> output wire (x4)
- Replace ad9484_lvds_to_cmos_400m with ad9484_interface_400m
- Remove duplicate IBUFDS lvds_to_cmos_400m instantiation
- Remove non-existent ref_i/ref_q port connections on matched filter
- Connect adc_dco_bufg as 400MHz clock source
ad9484_interface_400m.v:
- Add adc_dco_bufg output port with BUFG instance
- Route all internal logic through buffered DCO clock
cic_decimator_4x_enhanced.v:
- Move reset_monitors handling inside else branch (fixes Vivado
ambiguous clock error in both integrator and comb always blocks)
- Add separate comb_overflow_latched/comb_saturation_detected regs
to eliminate multi-driven nets between integrator and comb blocks
- Remove standalone always @(posedge reset_monitors) block
- Add output_counter to async reset branch
matched_filter_processing_chain.v:
- Wrap behavioral FFT body (uses $cos/$sin/$rtoi) in ifdef SIMULATION
- Add synthesis stub tying outputs to safe defaults
chirp_memory_loader_param.v:
- Replace hardcoded Windows paths with relative filenames for all
10 $readmem default parameters
latency_buffer_2159.v:
- Split single always block into separate BRAM write (synchronous
only) and control logic (with async reset) blocks
- Fixes Vivado Synth 8-3391: BRAM cannot infer with async reset
xfft_32.v (NEW):
- Synthesis stub for Xilinx 32-point FFT IP core
- AXI-Stream interface with pass-through and 1-cycle latency
- Placeholder until real xfft IP is generated
2026-03-15 17:37:59 +02:00
c871281f1e
Fix synthesis blockers in 9 RTL files for Vivado compatibility
...
Guard all $display/$error/$time calls with ifdef SIMULATION in:
- chirp_memory_loader_param.v (initial + always block debug prints)
- cic_decimator_4x_enhanced.v (5 saturation/overflow displays + monitor block)
- ddc_400m.v (FIR/baseband debug monitor block)
- fft_1024_inverse.v (IFFT config debug block)
- matched_filter_multi_segment.v (16 state machine displays + monitor)
- nco_400m_enhanced.v (initial block debug print)
- radar_receiver_final.v (frame/chirp counter displays)
Replace SystemVerilog constructs with Verilog-2001:
- usb_data_interface.v (typedef enum -> localparam + reg)
- usb_packet_analyzer.v (typedef enum -> localparam, output reg -> wire)
2026-03-15 14:53:35 +02:00
f5a3394f23
Add 3 missing FPGA modules with enhanced testbenches (168/168 pass)
...
Implement the 3 modules identified as missing during repo audit:
- matched_filter_processing_chain: behavioral FFT-based pulse compression
- range_bin_decimator: 1024→64 bin decimation with 3 modes + start_bin
- radar_mode_controller: 4-mode beam/chirp controller
Wire radar_mode_controller into radar_receiver_final.v to drive the
previously-undriven use_long_chirp and mc_new_* signals.
Implement start_bin functionality in range_bin_decimator (was dead code
in the original interface contract — now skips N input bins before
decimation for region-of-interest selection).
Add comprehensive testbenches with Tier 1 confidence improvements:
- Golden reference co-simulation (Python FFT → hex → bin comparison)
- Saturation boundary tests (0x7FFF / 0x8000 extremes)
- Reset mid-operation recovery tests
- Valid-gap / stall handling tests
- Mode switching and counter persistence tests
- Accumulator overflow stress tests
Test counts: matched_filter 40/40, range_bin_decimator 55/55,
radar_mode_controller 73/73 — all passing with iverilog -g2001.
2026-03-15 13:37:10 +02:00
76183e2e95
Fix 6 RTL bugs in FPGA signal processing chain
...
- nco_400m_enhanced.v: Correct sine LUT values (3.7x quadrature error)
- ddc_400m.v: Fix wire forward-declaration (Verilog-2001 compliance)
- plfm_chirp_controller.v: Remove multi-driven chirp_counter (critical)
- radar_system_top.v: Fix CFAR wire-as-reg, connect chirp_counter to receiver
- radar_receiver_final.v: Promote chirp_counter to input port
All fixes verified with Icarus Verilog 13.0 testbenches (144/144 tests pass).
2026-03-15 06:14:04 +02:00
5fbe97fa5f
Add files via upload
2026-03-09 00:17:39 +00:00
Jason
NawfalMotii79