Bug #11: platform_noos_stm32.c used HAL_SPI_Transmit instead of
HAL_SPI_TransmitReceive — reads returned garbage. Changed to in-place
full-duplex. Dead code (never called), fixed per audit recommendation.
Test added: test_bug11_platform_spi_transmit_only.c. Mock infrastructure
updated with SPI spy types. All 11 firmware tests pass.
FPGA B2: Migrated long_chirp_lut[0:3599] from ~700 lines of hardcoded
assignments to BRAM with (* ram_style = "block" *) attribute and
$readmemh("long_chirp_lut.mem"). Added sync-only read block for proper
BRAM inference. 1-cycle read latency introduced. short_chirp_lut left
as distributed RAM (60 entries, too small for BRAM).
FPGA B3: Added BREG (window_val_reg) and MREG (mult_i_raw/mult_q_raw)
pipeline stages to doppler_processor.v. Eliminates DPIP-1 and DPOP-2
DRC warnings. S_LOAD_FFT retimed: fft_input_valid starts at sub=2,
+1 cycle total latency. BREG primed in S_PRE_READ at no extra cost.
Both FPGA files compile clean with Icarus Verilog.
Reduce routing pressure on CIC/NCO critical paths and move Doppler BRAM read-address registers to sync-reset datapath logic so Build 13 closes with stronger setup/hold slack while preserving functional behavior.
Previously the S_IDLE->S_ACCUMULATE transition consumed one data_valid
cycle without writing to BRAM, losing the first sample. The testbench
worked around this by sending sample[0] twice.
Fix: drive mem_we + data capture in S_IDLE on the transition cycle and
advance write_range_bin to 1. Testbench workaround removed.
Verified: 3/3 Doppler co-sim BIT-PERFECT, integration test 10/10 PASS.
Jason
NawfalMotii79